Siemens Gamesa announces the launch of its next-generation wind turbine
Siemens Gamesa Renewable Energy to introduce its next-generation wind turbine, the SG 3.4-145. The new wind turbine is specifically designed and optimized for wind...
DR SATYA GUPTA APPOINTED AS THE CHAIRMAN OF IESA FOR 2020 -2021
- The Electrical India Content Team
On the 5th of May 2020, SEMI reported its Power & Compound Fab report for the year 2024, in...
KEI Industries pledges to support India’s battle against COVID-19
-By Electrical India Content Team
On the 1st of April 2020, KEI Industries pledged Rs. 2 Cr to the PM Care Fund supporting the fight...
A Review of Battery Charger Topologies and Infrastructure for Plug-In Electric and Hybrid...
The article is authored by Dr L Ashok Kumar, Professor, Department of Electrical & Electronics Engineering, PSG College of Technology, Coimbatore
An Introduction:
There is growing...
BUSDUCT SYSTEM DESIGN Part 3
The reactance thus obtained can be doubled for single phase systems. For a three phase system the configuration of the three phases with respect...
REC LIMITED SUCCESSFULLY RAISES 3-YR USD 500 MN BONDS, FIRST USD CROSS BORDER ISSUANCE...
- The Electrical India Content Team
REC Limited, a Government of India PSU and one of India’s power financiers, opened up the USD markets for...
GAS TURBINES THE HEART OF POWER GENERATION
- The article is authored by Dr Iyad Al-Attar
Dr Iyad Al-Attar is a Mechanical Engineer, and business innovator. He is also a Visiting Academic...
BUSDUCT SYSTEM DESIGN Part 1
In order to have low losses and enhanced reliability in the distribution system, bus-ducts are preferred over cables for higher current ratings and shorter lengths at different voltage levels. Though Sandwich Bustrunking System with rated operational voltage (Ue) 1000 Volt are easily available, when it comes to economics–Air insulated bus ducts have an edge. This article focuses on the types of air insulated busducts and their selection guidelines, design requirements, de-rating factors and sizing requirement...
Panacea of Challenges in the COVID-19 ERA
Over the last year, with the world still gripped by the COVID-19 pandemic, semiconductor-enabled technologies allowed us to remotely work, study, treat illness, order...
INDIA’S SEMICONDUCTOR PURSUIT GETS A STRONG PUSH
The Semiconductor Industry Association (SIA), the top trade association representing the U.S. semiconductor industry, has recently signed a Memorandum of Understanding (MoU) with the...
Mitsubishi Electric’s new 6.5 kV Full-SiC Power Semiconductor Module
Mitsubishi Electric Corporation revealed that it has developed a 6.5 kV full silicon carbide (SiC) power semiconductor module that is believed to offer the world's highest power density (calculated from rated voltage and current) among power semiconductor modules rated from 1.7 kV to 6.5 kV.
BUSDUCT SYSTEM DESIGN – Part 2
Voltage Drop
The voltage drop across a bus system should be as low as possible and generally within 2% of the rated voltage. The length...
MV Covered Conductors: Safety Solution for Wildlife
Using Bare Conductors on the overhead distribution lines in forest and wild life sanctuaries resulting fatal accidental death of several wildlife animals and big birds due to electrocution. - Manish Patel
Bright Future in the Semiconductor Industry
The article examines what the semiconductor industry is, why it’s important – and what skills are required to go in this filed…
PXIL and its employees contribute towards the PM-CARES Fund
-By Electrical India Content Team
Power Exchange India Limited (PXIL) has made its contribution to the Prime Minister’s Citizen Assistance and Relief in Emergency Situations...
6 Common Differences Between Reflective and Conventional Mass Insulation
Reduction of heat transfer from outside to inside of a building lowers the cost of (electricity) cooling during summer days...
High Temperature Superconductors Wires And Cables: Technologies Of Energy Conservation
Emerging technologies of High Temperature Superconductors (HTSrs) have an enormous potential for improving capacity of underground and overhead power T&D systems, motors, generators and power plants – because higher Jc and zero resistance of HTSrs reduce losses and can replace conventional conductors... - Hambir Singh
ON TIDES OF CHANGE: EXPLORING THE KGS IN INDIA
- By the Electrical India content team
India presently has an installed wind energy capacity of approximately 37 GW. Also, it has a target of...
MHPS’ T-Point 2 technology now attains commercial benchmark
Mitsubishi Hitachi Power Systems’ (MHPS’) T-Point 2 combined cycle power plant validation facility has recently entered full commercial operation with an enhanced JAC gas...
CPC originates new 1″ MPU Series connector for high-flow bioprocessing demands
CPC (Colder Products Company), part of DOWNERS GROVE, Ill. has introduced the 1" MPU Series connector for use with high-volume, large-flow fluid transfer in...